Maintenance of Antistatic Access Floor

Maintenance of Antistatic Access Floor

1. Operating environment:

Environmental control requirements for rooms with anti-static floors: temperature: 15 ℃ ~ 35 ℃, relative humidity: 45% RH ~ 75% RH;

2. Decorative floor:

2.1 it is forbidden to directly construct and operate sharp and sharp instruments on the decorative surface of the raised floor to prevent damaging the anti-static performance and beauty of the decorative surface;

2.2 in the process of use, it is forbidden for personnel to jump directly onto the anti-static floor from a height, and to carry objects savagely when moving, so as to damage the floor;

2.3 when moving objects on the raised floor, it is forbidden to push objects directly on the board surface, so that the objects can directly rub with the ground, resulting in scratches on the board surface;

2.4 when handling articles, the cart with rubber wheels shall be used for handling, or the isolation pad shall be laid between the outline of the object and the floor to prevent damage to the board surface;

2.5 when placing heavy objects on the anti-static movable board, they should be arranged stably to avoid damaging the anti-static floor;

2.6 during the maintenance of the equipment in the lower space of the floor, the floor shall be installed with the floor absorber, and the floor shall be handled with care to avoid damaging the anti-static floor;

2.7 during use, clean mop and rag can be used to keep the board clean. Pay attention not to sprinkle a large amount of water, detergent and other liquids on the floor, so as not to affect the service life of anti-static floor and the normal operation of lines and equipment under anti-static floor;

3. Bare floor and ventilation

3.1 the scratch of the anti-static plastic spraying layer of the raised floor shall be prevented during use. If the scratch is found, it shall be repaired with gray paint to ensure the integrity of the coating.

3.2 prevent small objects from falling into the vent of the ventilation floor (such as coins, keys, paper clips, pins, etc.) to avoid damaging the ventilation regulator and other equipment.